Car Features

Rosalia – 1957 Pontiac Super Chief

The Pontiac Super Chief is a rare beast these days, but this two-owner car may also be a one-off. Its original owner claimed that it was the only completely-built-up 1957 model brought into Australia.

 

 

 

The Australian-market Pontiac Super Chief was derived from the US Chieftain range, but, because of favourable tariff arrangements between British Commonwealth countries, it was produced in GM’s Canadian plant, in Oshawa, not in Michigan, in the USA.

As with some other non-Holden GM brands, Pontiac flat-pack, semi-knocked down (SKD) kits were produced in Canada, shipped across the Great Lakes to Michigan, then sent via the Pacific Ocean to Australia and assembled by General Motors-Holden (GMH). 

The number of 1957 Pontiac Super Chiefs sold by GMH is not documented, but estimates suggest only a few hundred. The 1957 model was a one-year-only offering, because the 1958 model was rebadged as the Strato Chief.

 

 

 

 

Super Chief data

 

The 1955-58 Chieftain range was built around a new chassis, body and Pontiac’s first overhead-valve V8: the Strato Streak V8. This 287 cu in (4.7-litre) engine made 180bhp at 4400rpm and, for 1956, it was enlarged to 317 cu in (5.2  litres), with 192-205bhp. 

 

 

New ‘Star Flight’ styling appeared on 1957 Chieftains, with missile-shaped side trim, extended rear fenders with V-shaped tips, lower hoods and massive bumpers. Engine displacement was again increased, to 347 cu in (5.7 litres), producing 290bhp and the first Tri-Power, triple two-barrel carby, Pontiac engines were also available.

Some Canadian Pontiac models were known as ‘Cheviacs’, because they were built on the cheaper and more popular Chevrolet chassis, with 115-inch wheelbase, so the Pontiac front and rear panels were shortened accordingly. However, Canadian-made Australian Pontiac Super Chiefs were built on the standard 122-inch-wheelbase Pontiac chassis.

 

 

 

The featured car has VIN P757S2501, indicating: Pontiac, Michigan assembly; model year 1957; S for Super Chief and 2501, its sequential production number, which certainly looks like the first of its series.

 

 

The car’s Body Style 57-2719D indicates: 1957 model year; series 27 (Super Chief) and 19D for a four-door sedan.

The body and trim codes confirm it has Fisher bodywork and two-tone green body colour and interior. The accessories code confirms right-hand-drive engineering.

Incidentally, the 1957 Australian models used the dashboards and steering columns from the 1956 cars, because it was deemed unnecessary to re-engineer the 1957 LHD  components that were only stylistically different.

 

 

Australian Super Chiefs were also given taller front suspension and more cambered rear leaves, to raise static ride height by two inches (50mm), to better suit Australian road conditions.

OK, so checking the codes indicates Canadian production in RHD for Australia, but can’t confirm the claimed provenance for this particular car, which is that this Aussie 1957 Super Chief arrived fully built up Down Under, with a 2BBl carby and three-speed manual transmission, and was the initial GMH promotional vehicle.

This factory provenance was provided by its original owner, who was a post-WWII immigrant to Australia and subsequently an employee at GMH’s plant in Adelaide, back in the 1950s.

In 1958 this owner was involved in the Australian assembly of Pontiac SKD packs. He told the current owner, Nathan N, that the car arrived fully built up, following assembly at GM’s Pontiac plant in Michigan and remained in GMH ownership during 1958. He bought the car from his employer after the Super Chief had finished its production run and then owned it for more than 60 years. 

He said the car arrived fully built up from the USA and was accompanied by 250 SKD flat-pack cars, for GMH assembly.

Nathan N bought the car in 2021 from its then 91-year-old first owner, who had just lost his wife of 70+ years, after whom the car had been given the name, Rosalia.

 

 

Although retaining its stock appearance, Rosalia had a respray in as close to the original colours as Nathan N could get. The fender ‘rockets’ were rewired to act as indicators and the exhaust plumbing was routed through the bumper, as in the Bonneville. 

The Super Chief scored a new steering column, after the original simply wore out. 

 

 

The three-speed manual was swapped for a T350 auto. Engine bay upgrades included a 4BBL carby and EP4B manifold, and an aluminium radiator. 

The wheels were upgraded from 14-inch to 15-inch, to improve rough-road tyre choices.

This beautifully presented 1957 Pontiac Super Chief is significant enough, in being a survivor of only the few hundred that were brought Down Under some 70 years ago, but also has what seems to be unique provenance. 

 

 

 

 

Stay informed and receive our updates

From Jim Gibson & Allan Whiting directly to your inbox

You have Successfully Subscribed!